japanese maple leaf origami crease pattern satoshi kamiya

Crimp the thickflaps out an an -angle.ġ41. Fold inside incorporatinga little swivel in the center.ġ38. Fold over flatteningthe central edge.ġ37. Reverse fold distributing thelayers out.as evenly as possible.ġ34. tift the center and swingthe new ,flap 10 the ,left.ġ28. Rabbit-ear the comer flippingthe rear flap back in front.ġ18, Mountain-fold matchin~up with the edge behind.ġ2 1. Fold and unfold dividingth.e anqle 'into fourths,ġ09. Fold and unfold alongthe angle bisector.ġ01. Add a small swiveland fold one layer over.ġ06. Fold and unfold liningup with the ,edges behind.ġ03. Fold the narrow edge oversquashing at the bottom.ĩ1. Lift the center and swingthe new flap to the left.Ĩ9. Notethe position ofthe thick hidden edge.Ĩ8. A small triangle above thissection is not shown. Crease pattem ,of middlesection from above. Fold the edge to the right.Ĩ0 Reverse-fold both edges inand out and at the the dark region inside. Pleat to the rtght while simultaneouslysinking.a hidden edge.ħ7. Wrap one layer in front.Ħ9, Fold all the layersback to the right.Ħ8. Bring the two dotstogether with a squash-fold. Invert the bottom edgeand pleat the loose paper Up.Ħ7. The top of themodel will not lie flat.Ħ0. Fold the flap to theleft lining it up with theedges behind.ĥ6. Fold all the layers to the fronton the right while folding the layersbehind on the. Side view of the sinkfrom the previous step.ĥ2. Petal-fold using existingcreases as guides.ĥ1. Fold the edges to thecenter starting at the bottom.Ĥ3. Open-sink in and out, exceptleave the pleat from step 46 closed.ģ8. Open up the bottomof the model creasinggently where shown.Ĥ8. swingingthe resulting flap to the left.ģ7.

Fold to the center again whilepetal-folding the small edge.ģ0. The following stepswill only show the top triangle.Ģ4. Pleat the bottom edgesout flattening the center flapin the process.Ģ1.

Again, bring one layerin front on both sides.ģ2.

You mustbring the small edge noted in step 28 infront as w.ell or the next step will tear.Ģ6. Bring one layer in front, you will have toopen the model somewhat to accomplish this.ĢB. Fold and unfold dividingthree regions in haltġ1. Fold and unfold throughthe intersections. Fold and unfold throughthe crease intersections.ħ. Fold to the center and unfoldcreasing only as far as shown.ĥ. Fold andunfold in half both ways.ĭifficulty: **** ComplexDesigned: 2002 Revised: 2005, 2012Recommended starting size: 14 inches (35 cm)Finished aize: 6 inch wingspan (17 em)Expected time needed to fold 3-4 hoursĤ.

Japanese maple leaf origami crease pattern satoshi kamiya